24
Notes:
1
）
In 2-00 and 2-01, when 2-00 has been set as d1(AVI) or d2(ACI), 2-01 can't be set as d1 or d2 again.
2
）
In 2-00 and 2-01, when 2-00 has been set as d6 or d7 (controlled by UP/DOWN), 2-01 can't be set as d6 or d7
again.
3) The parameter of 2-07 is valid only when the frequency is given by analog input AVI and input set 0. If the
frequency is given by AVI, but press the STOP key, the inverter will stop still according to the mode of 2-04.
3. Output Function Parameters
Set during running available
Parame
ter
Parameter functions
Setting range
Factory
setting
3-00
Frequency detection(Level)
1.0 to 400Hz
1.0
3-01
Count value agreement setting
0 to 999
0
3-02
Appointed count agreement setting
0 to 999
0
3-03
Fwd run reference delay setting
0.0 to 60.0s
0.0
3-04
Rev run reference delay setting
0.0 to 60.0s
0.0
3-05
Terminal[RA/RB/RC] Function(Relay
output)
Normally Open Contactor (RA-RC)
Normally Closed Contactor (RB-RC)
0: No function
1: Inverter running
2:Frequency arrival
3: Zero speed
4: Over-torque detection
5: During external alarm
6. Low voltage detection
7: External terminal running mode
8: Alarm output (for any alarm)
9: Frequency detection
10:During pattern operation
11:Pattern operation one cycle completion
12.Pattern operation completion
13:Pattern operation pause
14:Terminal count value arrival
15:Terminal designated count value arrival
16:Inverter ready to run
17:Fwd running
18:Rev running
19:Fwd/ Rev run direction
8
3-06
Analog output setting
0:Output frequency 1 (before slip
compensation)
1:Output frequency 2 (after slip compensation)
2:Analog current meter (0 to 250% of rated
current)
3: Analog output voltage
4: Analog DC bus voltage
5: Input power
0
3-07
Reserved
3-08
Analog output gain selection
1 to 200%
100
