Riello 20120391, Инструкции для установщика и технической поддержки

Страница: 139 / 188

139
CONTROL PANEL
INSTALLATION
SYNOPTIC PAGE
Synoptic page allows monitoring the steam-cooling cycle. The
diagram indicates unit current status providing information
about its capacity, pump status of the water heat exchanger
and pre-set setpoint parameter.
All unit functions can be accessed by pressing the Main Menu
push-button.
1 2 4 5 6 3
1 Home
2 Main menu
3 Current control pa-
rameters
4 Login
5 Start/stop
6 Alarms
The bell on the top right-hand side of the screen
will light up when an error is detected.
9
The synoptic page display may vary based on the pump
configuration.
LANGUAGE SELECTION PAGE AND UNIT OF MEASUREMENT CHANGE
PAGE
The display language can be changed in the User's Login Page
on the user interface.
To change a display language:
− Press Login .
− Select new display language.
3.6.3 Main pages of the control panel
Connect Touch allows accessing the control panel pages. The
main pages are:
− Welcome page (home page)
− Synoptic page
− Language selection page and unit of measurement
change page
− Password entering and change page
− Operating mode selection page
− Parameter change page
− Programming page
WELCOME PAGE
The welcome page is the first to be displayed after starting the
user interface. It shows the number of software current ver-
sion.
To quit the welcome page and move to the Home page, press
Home .
1 2 3
1 Home push-button
2 Software version number
3 Dialog box
The information window shown in the status bar at the bottom
of the screen includes important messages on the user current
action.
The messages that can be displayed are the following:
MESSAGE
(1)
STATUS
COMMUNICATION
ERROR!
The equipment controller did not reply
during table content reading.
ACCESS DENIED!
The equipment controller denies ac-
cess to one of the tables.
LIMIT EXCEEDED!
The entered value exceeds the param-
eter limit.
Do you want to save
changes?
Changes have been made. Press Save
or Cancel to be able to quit the page.
BYPASS IN PROGRESS!
The equipment controller refuses the
Bypass or Auto control.
Too many users
connected! Try again
later...
Too many users connected at the
same time
(WEB INTERFACE ONLY).
(1) These messages will be displayed if the Italian language has
been set.