Installation
Section 3.
3.2.1
INSTALLATION
WARNING
ALL RFL 9508D UCC TERMINALS ARE EQUIPPED WITH A PROTECTIVE
COVER THAT EXTENDS ACROSS THE REAR OF THE CHASSIS. THIS COVER
IS INTENDED TO PROTECT THE OPERATOR FROM POTENTIALLY
HAZARDOUS VOLTAGES WHICH MAY BE PRESENT ON THE REAR-PANEL
TERMINAL BLOCKS. THIS COVER MUST ONLY BE REMOVED BY QUALIFIED
SERVICE PERSONNEL WHEN ACCESS TO THE REAR PANEL IS REQUIRED. IT
MUST BE REPLACED BEFORE PLACING THE 9508 TERMINAL IN SERVICE.
3.1
INTRODUCTION
This section contains installation instructions for the RFL 9508D UCC, including unpacking,
mounting, and interconnection wiring. Refer to Table 3-4 at the end of this section for a list of modules
used in the RFL 9508D UCC.
3.2
UNPACKING
RFL 9508D UCC equipment is supplied in sets of at least three chassis, which may be interconnected
with other chassis or assemblies as part of a system. Paragraph 3.2.1 provides unpacking instructions
for individual chassis, and paragraph 3.2.2 provides instructions for interconnected chassis.
INDIVIDUAL CHASSIS
RFL 9508D UCC terminals supplied as individual chassis are packed in their own shipping cartons:
1.
Open each carton carefully to make sure the equipment is not damaged.
2.
After the chassis is removed from the carton, carefully examine all packing material to
make sure no items of value are discarded.
3.
Carefully remove any packing materials inserted into the chassis to hold circuit cards in
place during transit.
RFL 9508D UCC
RFL Electronics Inc.
June 14, 2011
3-1
(973) 334-3100
