Reely ROAD 23 49 70, Руководство по эксплуатации

Страница: 46 / 137

43
© REELY 01/08
4 P
REPARATION
S
COPE OF DELIVERY
- One Chassis
- 5,89 ccm two stroke glow engine
with 2,77 kW (3,76 HP),
with manifold, resonance tube and air filter
- 2-speed drive with metal cogwheels
- Clutch bell with aluminium clutch cheeks
- Steering servo, Throttle/brake servo and receiver,
already mounted
- fuel hoses, already laid.
- Four wheels with plastic rims and
already mounted tires with linings
- Stadium Buggy car body, imprinted
- Splints to fasten car body
- A plastic tube as guidance for the wire aerial
- Spring pretensionner set
- one two-channel remote control
(pistol grip transmitter)
- This operating manual
R
EQUIRED ACCESSORIES
N
OT INCLUDED IN THE DELIVERY
:
- 12 accumulators for the transmitter and the receiver
- Glow plug and
- plug spanner
- Plug connector with rechargeable battery as a unit and
- battery charger
- Tank bottle
Also available as a complete set
Nitrobox II Combuster no. 23 07 99
incl. transport box
- Charger (220V) for the rechargeable batteries or
quick charger to connect to a 12V car battery
- Model fuel methanol/oil based,
minimum share 5% - 10% nitromethane
S
COPE OF DELIVERY
,
NECESSARY ACCESSORIES
4.1
S
PARE
P
ARTS
The spare part list can be found on our Website www.conrad.com in the Download domain specific to the corresponding product.
Alternatively, you can order the spare parts by phone; the contact details are at the beginning of this operating manual in chapter
“Introduction”.
A
CCESSORY RECOMMENDATION
Which type of fuel is the right one?
The selection of the fuel has an impact on the performance characteristic of the engine.
However, as a matter of principle:
- In the running-in phase, a special RC car fuel with approximately 16% nitromethane should be used.
- After the run-in of the engine (after a mere operating time of approximately 45 minutes), you can change to a fuel with approximately 20%
nitromethane.
- For maximum output, we recommend the max. percentage of 25% nitromethane
Use fuel for RC cars only!
The percentage of oil contained in fuel for RC plane engines is too small (too little lubrication), which causes the
engine to overheat, thus leading to serious damages.
The same is valid for vehicle gasoline.
Why is a tank bottle needed?
RC model car fuel is available in big bulks (canisters) only. Filling the tank by using a smaller, special tank bottle with a small, curved pouring tube is
significantly simpler. You also prevent spilling fuel (expensive and poisonous).
Are more glow plugs necessary?
Glow plugs wear, especially in the running-in phase. Therefore, we recommend having some glow plugs ready in case of need for a replacement. There
are glow plugs with different calorific values; the selection of the glow plug has a big impact on driving performance. For the running-in phase, you
should use a “hot” glow plug for high performance engines. After the running-in phase, you can use a glow plug with a middle or a “cold” calorific value.
Use glow plugs for RC cars only! A wrong glow plug, such as e.g. for 4 stroke plane engines, lets the engine run incorrectly and
complicates the tuning.
Replacing the glow plug
To that effect, you need an extra long plug spanner (spider wrench SW 8, 9, 10 and 12), which can be used also to unscrew the outer hexagonal
screws.
Preheating the glow plug
A plug connector (long) with rechargeable battery as a unit is inserted on the glow plug and heats the latter, so that the air-fuel mix sparks off and the
engine starts. When the engine runs smoothly, the plug connector can be removed.