Phason Plus Touch Series, Руководство пользователя

Страница: 44 / 93

Chapter 4: Programming the Plus Touch
44
And With Next modifiers
must meet two conditions before setting or adjusting the output. For
example, “When the temperature is over 80°F and the humidity is over 90%, switch on a fan.”
To view modifiers

Press the left or right arrow beside Output to view or choose which variable stage or relay you
want to modify.

If you have two or three modifiers for an output, press the left or right arrow beside Modifier to
view them.
To program “set value” or “and with next” modifiers
1. Press the
Menu
and then
Settings
.
2. Press
Modifiers
.
3. Press the
Left
or
Right
arrows beside Output and Modifier to choose the output and modifier you
want to program.
4. Press the button beside Mode and then select Set Value .
5. Press the button beside Type and then select one of the sensor types. If you have more than one
of the above types of sensors, beside Sensor , press the button and then select the specific sensor.
6. Press the
<
or
>
below Comparison to choose whether you want to modify when the sensor
reading is less than or greater than the value.
7. Press the
Up
or
Down
arrows below Value to set the value to which the sensor reading will be
compared.
8. If you are programming a “set value” modifier, press the
Up
or
Down
arrows beside Set Output to
set the output the stage or relay will be at while modified.
9. When finished, press
Save
.
To program “influence” modifiers
Influence modifiers are for variable stages only.
1. Press the
Menu
and then
Settings
.
2. Press
Modifiers
.
3. Press the
Left
or
Right
arrows beside Output and Modifier to choose the output and modifier you
want to program.
4. Press the button beside Mode and then select Set Value .
5. Press the button beside Type and then select one of the sensor types. If you have more than one
of the above types of sensors, beside Sensor , press the button and then select the specific sensor.
6. Press the
Up
or
Down
arrows below Start At and End At to set the range of values within which
the stage or relay will be modified.