Phason Plus Touch Series, Руководство пользователя

Страница: 34 / 93

Chapter 3: Configuring your Plus Touch
34
To configure relays for inlets
1. Press the
Menu
and then
Configuration
.
2. Press
Equipment
.
3. Scroll to and then press the relay you want to configure.
The Equipment Configuration screen displays.
4. To rename the inlet, press
Rename
.
5. Press
Reset
and then type the new name. When finished, press
Confirm
to save the change and
return to the Configuration screen.
6. Select the zone containing the equipment. If the equipment will not belong to a zone, skip this
step.
7. Select the function of the inlet: inlet with feedback or inlet without feedback.
8. To enable or disable deicing, press
Enable Deicing
. There is a check in the box when enabled.
9. When finished, press
Save
.
Calibrating inlet actuators
After you configure relays for inlet actuators, you need to calibrate the actuators. Calibrating the
actuator lets the control know the position of the actuator when it is fully extended and fully
retracted. Plus Touch uses the limits to define the range of motion it uses to position the inlets. The
limits tell the control how much to adjust when you want the inlets open 25 percent, for example.
During calibration, the actuator opens, pauses, and then closes. If the actuator is operating properly,
the inlet should open completely and then close completely. After closing completely, the actuators
should position according to the temperature and default settings.

Before calibrating actuators, make sure the limit switches are set and the cable
and counter weights can move freely.

If calibration stops after closing the first time or fails to position properly, the
feedback signal is not connected correctly. Verify the potentiometer wiring. For
more information, read
Determining correct actuator feedback wiring
on page
75.

Because cables can stretch and equipment can come out of alignment, we
recommend you reset the limit switches and calibrate your actuators at least
once each year.