Phason Plus Touch Series, Руководство пользователя

Страница: 23 / 93

Finishing the installation
23
Connecting the power source

Before connecting the incoming power, switch OFF the power at the source.

Do not switch ON the power until you have finished all wiring and verified all
equipment is properly connected and free of obstructions.

Before connecting the power, set the voltage selection switch to the correct
voltage.

If you are using three-phase power, make sure the control power and the
variable speed fans are connected to the same phase. For more information,
read
Using three-phase power
on page 19.
You can connect the Plus Touch to 120 or 230 VAC, 50 or 60
Hz power.
To connect the incoming power source
1. Set the voltage select switch to the correct voltage setting.
2. Connect the incoming power source as shown below.
Finishing the installation
After installing and connecting equipment to the Plus Touch, you are ready to finish the installation.
Before you start configuring the control, you need to verify the connections and configuration.
Make sure the configuration worksheets in
Appendix D
correspond to the way the equipment is
connected to the Plus Touch. It is very important that the connections and the worksheets are the
same, because the next step after closing the cover is to tell the Plus Touch which equipment is
connected to each terminal. It is important so you can be sure you are controlling the equipment you
think you are controlling.
1.
Make sure all the wires are properly connected to the correct terminals.
2. Make sure the voltage selection switch is in the correct setting, 115 or 230 VAC.
3. Make sure the display cable is properly connected. For more information, read
Bottom layout
on
page 12.
4. Place the cover on the control.