Setting the Output Conditions
158
ZW-8000/7000/5000
User's Manual
The range of cut-off frequency to be effective in operation varies depending on the setting of measurement
cycle.
The relationship between the measurement cycle and the cut-off frequency range is shown in the table below.
• If a value outside of the appropriate range is set, the frequency filter will be applied with the values included in the
range.
• If the cut-off frequency values (upper/lower limits) are too close, the frequency bandwidth to be detected cannot be
properly detected.
• If changing the extension fiber cable length setting causes the setting value of the cutoff frequency to fall outside the
upper/lower limit value, the setting value is automatically changed to the value within the limit.
Frequency filter is applicable the measurement result executed TRIG input/Sync0 signal even if select the External/
PDO synchronous measurement mode. In this case, the sampling interval of measured result is used the
measurement cycle value which has been set and executed external TRIG input/Sync0 signal.
The value is not dependent on the interval which is actually executed TRIG input/Sync0 signal.
Measurement cycle
[
μ
s]
Sampling
Frequency
[Hz]
Cut-off frequency range [Hz]
High-pass filter
Band-pass filter
Low-pass filter
Lower limit
Upper limit
Lower limit
Upper limit
20
50000
1275
23725
20
23725
40
25000
638
11862
10
11862
60
16667
425
7907
7
7907
80
12500
319
5931
5
5931
100
10000
255
4744
4
4744
200
5000
128
2372
2
2372
300
3333
85
1581
1.5
1581
400
2500
64
1185
1
1185
The frequency filter can also be set by the operating keys on the Sensor Controller.
Setting the Frequency Filter p.244
Note
Important
Important
Содержание ZW-7000 Series
