Omron ZW-7000 Series, Руководство пользователя

Страница: 106 / 336

Displaying measured values in graphs
104
ZW-8000/7000/5000
User's Manual
3
Select data to monitor the trend for.
Set data to monitor the trend for.
The types of data that can be set are as follows.
4
Set the logging sampling interval.
Set the logging sampling interval for the target data.
* 1: The types of values that can be set vary depending on the measurement cycle being set.
Values outside the following range cannot be set.
0.5 [ms]/Measuring cycle [ms] to 100 [ms]/Measuring cycle [ms]
5
Click the Start icon ( ) to start the sampling.
When the sampling starts, the sampled data is displayed in the graph.
6
Click the End icon ( ) to end the sampling.
When the sampling ends, the graph display stops too.
Item Setting item Description
Target data OUT1 Measurement results assigned to OUT1
OUT2 Measurement results assigned to OUT2
OUT3 Measurement results assigned to OUT3
OUT4 Measurement results assigned to OUT4
TIMING TIMING input signal (parallel I/O)
ZERO ZERO input signal (parallel I/O)
BUSY BUSY output signal (parallel I/O)
ENABLE ENABLE output signal (parallel I/O)
HIGH HIGH output signal (parallel I/O)
PASS PASS output signal (parallel I/O)
LOW LOW output signal (parallel I/O)
TASKSTAT TASKSTAT output signal (parallel I/O)
LOGGING LOGGING input signal (parallel I/O)
LOGSTAT LOGSTAT output signal (parallel I/O)
LOGERR LOGERR output signal (parallel I/O)
STABILITY STABILITY output signal (parallel I/O)
RESET RESET output signal (ParallelI/O)
LIGHT_OFF LIGHT_OFF input signal (parallel I/O)
BUFFER_ERR Turn ON when dropping occurs.
Dropping may occur depending on the load factor of PC when acquiring
data from ZW-8000/7000/5000 series. If dropping occurs, increase the
arguments of logging.
Item Setting item Range Description
Sampling setting Logging sampling interval * 1 Set the sampling interval for the target data.
You can also specify the timing (start trigger, end trigger) for the graph display.
Note