Z86K15 ICEBOX
™
Emulator
ST97KEY0100
WARNING!
WARNING!
WARNING!
Follow the precautions listed below to avoid permanent damage to the emulator.
I. Always use a grounding strap to prevent damage resulting from electrostatic discharge (ESD).
II. Power-Up Precautions.
1. If the target application board has its own power, remove V
CC
jumper J1.
2. Ensure that all power to the emulator and the target application (if any) is turned off.
3. Connect the target pod to the target application (if any).
4. Power up the emulator.
5. Power up the target application (if any).
III. Power-Down Precautions.
When powering down, follow this procedure in the precise order shown below:
1. Power down the target application board (if any).
2. Power down the emulator.
NOTES:
1.
Refer to the “Precaution List” section of the Product Information document for additional
operating precautions specific to various devices.
2.
Do not leave the emulator powered up with the RS-232C cable connected to a powered-down
PC.
3.
Before inserting target pod into target application board, refer to Chapter 2 to determine
appropriate jumper selections and options.
Electrical
Safeguards
UM010001-0301
