![background image](http://html1.mh-extra.com/html/omron/sysmac-c200h/sysmac-c200h_operation-manual_742423330.webp)
Appendix C
Programming Console Operations
323
Cassette Tape Operations
Operation/Description
Modes*
Key sequence
Program Memory Save
Copies data from the Program
Memory to tape. The file no. specified
in the instructions provides an identi-
fying address for the information
within the tape. Each file number
should be used only once per tape. If
only a part of the Program Memory is
to be stored, the appropriate start and
stop addresses must be entered.
Each C60 tape can store approxi-
mately 16K words on each side of the
tape. When the start address is en-
tered, the maximum stop address is
set as the default. Do not set a stop
address greater than this one. If you
wish to record past this address the
additional information will need to be
recorded either on the flip side of the
tape or on a separate tape. After
starting the tape recorder, wait about
5 seconds before pressing SHIFT
REC/RESET. This is to allow the
leader tape to pass before the data
transmission starts.
P
EXT
A
0
WRITE
CLR
WRITE
Start recording with the
tape recorder.
SHIFT
REC
RESET
[File no.]
[Start address]
[Stop address]
After about 5 seconds**
(Cancel with the CLR key).
Program Memory Restore
To read Program Memory data which
has been recorded on a cassette
tape, the keystrokes are as given
here. The file number must be the
same as the one entered when the
data was recorded. The read opera-
tion will proceed from the specified
start address up to the end of the
tape, unless halted by a CLR com-
mand. The instruction must be com-
pleted before the required data is
reached on the tape, i.e., usually be-
fore the leader tape finishes.
P
PLAY
SET
EXT
A
0
WRITE
CLR
SHIFT
Start tape recorder
playback.
[File no.]
[Start address]
Within about 5 seconds**
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM
**These times take the cassette leader tape into consideration according to the following:
a) When recording to tape, the leader tape needs to be allowed to pass before the data transmission to the tape player starts.
b) When restoring from tape or comparing data, the Programming Console needs to be ready to receive data before the data is transfered
from the tape.
Содержание SYSMAC C200H
