![background image](http://html1.mh-extra.com/html/omron/sysmac-c200h/sysmac-c200h_operation-manual_742423325.webp)
Programming Console Operations
Appendix C
318
Programming Operations
Operation/Description
Modes*
Key sequence
Address Designation
Displays the specified address. Can
be used to start programming from a
non-zero address or to access an ad-
dress for editing. Leading zeros need
not be entered. The contents of the
address will not be displayed until the
down key is pressed. The up and
down keys can then be used to scroll
through the Program Memory.
R P M
CLR
[Address]
Program Input
Used to enter or edit program instruc-
tions. This operation over-writes the
contents of the memory at the dis-
played address. Once at the desired
address, enter the new instruction
word and then press WRITE (preced-
ed by NOT for differentiated instruc-
tions). Input the required operands,
and press WRITE after each.
P
Address
displayed
[Instruction
word]
[Operand]
Program Read
Allows the user to scroll through the
program address-by-address. If the
Program Memory is read in RUN or
MONITOR mode, the ON/OFF status
of each displayed bit is also shown.
R P M
Address
currently
displayed
Program Search
Allows the program to be searched
for occurrences of any designated in-
struction or data area address. To
designate a bit address, press
SHIFT, CONT/#, and then input the
address. Then press SRCH. Press-
ing SRCH again will find the next oc-
currence. For multi-word instruc-
tions, the up and down keys can be
used to scroll through the words be-
fore continuing the search. In RUN or
MONITOR mode, the ON/OFF status
of each monitored bit will also be dis-
played. Applicable data areas vary
according to the PC being used.
R P M
CLR
SRCH
SRCH
CLR
SHIFT
CONT
#
SRCH
SRCH
LR
HR
HR
SHIFT
TIM
CNT
[Instruction]
[Address]
(AR)
Scroll through multi-
word instructions
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM
Содержание SYSMAC C200H
