Quick
START
Crosslink-NX Voice and
Vision Machine Learning Board
This document provides a brief introduction to the Crosslink-NX Voice and Vision
Machine Learning Board. The board is pre-programmed to demonstrate the Human
Counting Demo.
1
2
Check Kit Contents
The Crosslink-NX Voice and Vision Machine Learning Board kit contains the following
items:
CrossLink-NX Voice and Vision Machine Learning Board
HM360 camera sensor (1 sensor, mounted on board)
USB Cable for Programming via PC (USB-A to Micro-B)
USB Cable for video output (Micro-B to USB-A)
Limited license with unique serial number for Lattice Radiant development software
(optional to use)
Quick Start Guide
Preparing the Hardware and Running the Demonstration
Follow the steps below to prepare the hardware and start the demonstration, which is
pre-programmed on the board.
Connect USB2 cable from PC to Config USB (J2). This will power the board with a
5 V supply.
Connect USB3 cable from Video Out USB3 to PC (J3)
No jumpers need to be placed on board
CY-USB-3014 (U13)
USB3 Out (J8)
Indicator LEDs
HyperRAM (U8:9)
Input Switches
and Buttons
PMOD0:1 (J4:5)
Power Indicator
LEDs
HiRes Camera
Connector (CN1)
Parallel Config
Header (J9)
LoRes Camera
Connector (U24)
Config USB (J2)
JTAG Header (J1)
PMOD2:3 (J6:7) LIFCL40-MG289 (US)
