Installation, Operating & Maintenance Instructions
Series 244, DN 10 - 50 (I.D.
⅝" - 2")
Series 245, DN 16 - 50 (I.D. 1" - 2")
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 [email protected] www.vatvalve.com
258343EE
2013-09-16
1/14
Vacuum Angle valve
(Series 244)
Vacuum Inline valve
(Series 245)
● with pneumatic actuator,
single acting with opening spring (NO)
This manual is valid for the valve ordering number(s):
244
…
24
5…
The fabrication number is indicated on each product as per the label
below (or similar):
made in Switzerland
Fabrication No.:
patented
. .
24
. . .
– . . . . – . . . . / . . . .
A
– . . . . . .
Fabrication number
Explanation of symbols:
Read declaration carefully before you start any other
action!
Keep body parts and objects away from the valve
opening!
Attention!
Hot surfaces; do not touch!
Product is in conformity with EC guidelines,
if applicable!
Loaded springs and/or air cushions are potential
hazards!
Disconnect electrical power and compressed air lines.
Do not touch parts under voltage!
Wear gloves!
Read these
«Installation, Operating & Maintenance Instructions»
and the enclosed
«General
Safety Instructions»
carefully before you start any other action!
