Omron F3SG-SR Series, Руководство пользователя

Страница: 81 / 399

53
F3SG-SR
User’s Manual
Chapter
2
PSDI
System Operation and Functions
E
2-10-2. Factory Default Setting
The PSDI function is set disabled.
2-10-3. Setting Change using Intelligent Tap
It is unable to change the setting of this function using the DIP Switch of the Intelligent Tap.
2-10-4. Setting Change using SD Manager 3
The following setting can be made using SD Manager 3.
* Set the minimum pressing time of the reset switch and pre-reset switch. The same minimum pressing time is applied to both
the switches.
It is recommended that the Position 2 of the DIP Switch be set at OFF (DIP Switch Disabled).
For the details of the setting change using SD Manager 3, refer to Chapter 4 Setting with SD Manager 3.
Function Initial value Configurable value or numerical range
PSDI function Disabled Disable/Single break/Double break
Minimum pressing time of reset switch * 100 ms 100 to 500 ms in 100-ms increments
T1
min.
T1
min.
T2
min.
Dummy
break
Dummy
break *
1
Dummy
break *
1
Unintended
break
Feeding
parts
Removing
parts
Feeding
parts
T3
min.
T4
min.
T2
min.
T3
min.
T6
Machine stops
T4
min.
T2
min.
T3
min.
T4
min.
T5
以上
T5
min.
Double Break
Reset switch (S1)
Press position
switch (S3)
OSSD
T1: Minimum pressing time of reset switch, configurable by 100 ms in a range of 100-500 ms
T2: Minimum break time (300 ms)
T3: Minimum unblocked time during the time from removing to feeding parts. T3 = T1
T4: Minimum break time (300 ms)
T5: Minimum pressing time of press position switch. T5 = T1
T6: Wait time until double break is complete (30 s or less)
*1. When the machine is stopped by unintended block in the middle of pressing of parts, operation of the reset switch (S1)
and then double dummy break are needed for reinitiation of the machine cycle.
*2. When Auxiliary Output is set to PSDI Information by the SD Manager 3.
AUX* 2
SEQ indicator
(yellow)
Beam state
Unblocked
Blocked
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON 1 time Solid-ON
Machine restarts