Olympus FLUOVIEW FV300, Руководство пользователя

Страница: 87 / 564

Getting Started FLUOVIEW/
Outline of LSM Observation Procedures
IV.
OPERATION INSTRUCTIONS
IV.
1 - 4 9
Page
1-2-12-8 Setting the Area to be Observed
When the observation targets are concentrated in a narrow area or when it is necessary
to observe the detail of a specific area, the image of a limited area can be acquired
selectively.
1. Increase the zoom ratio using the [Zoom] scale in the [Acquire] panel.
1-2-12-9 Setting a Lower Scan Speed
The scan speed can be decreased using the scale in the [Scan Speed] group box on the
center of the [Acquire] panel.
In general, setting a lower scan speed allows the acquired image quality to
be improved.
However, a low scan speed also lengthens the time required for image
acquisition.
When the scan speed is decreased during fluorescence observation,
the saturation of fluorescence may darken the image of certain types
of specimens. In this case, increase the scan speed and increase the
PMT Voltage or use accumulation in scanning.
The 4 buttons represent directions,
and clicking a button moves the
acquired image area in the direction
indicated by the button.
Clicking the square button on the
center returns the acquired image
area to the center.
Clicking a point in the scale area
allows the value to be changed
on a large scale.
Clicking the top or bottom arrow
button allows fine adjustment of
the value.
Dragging the square knob allows
the value to vary directly.
Click a point inside the circle to
change the position of the acquired
image area directly.
[Scan Speed] group box
Set the scan speed by clicking a point on
the scale line.
TIP
NOTE