Olympus FLUOVIEW FV300, Руководство пользователя

Страница: 127 / 564

APPLIED OPERATIONS
/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2 - 1 3
Page
5. Select the <BI> button in the [Observation] group box, and select the microscopy
from the option buttons below it. The system setting points to be changed for
microscope observation will blink in red.
6. Change the system configuration (setup of light path selector, etc.) by following the
guidance given by the red blinking light.
For the operation of the light path selector lever, see section 1-1-2,
“Microscope” in this volume.
The Red blinking indicates where can be changed. The blinking does
not stop even after the indicated configuration setting has been
changed.
7. While looking into the microscope, move the stage and check the observed image.
2-2-1-2 Configuring the Scan Un it
1. In the [Observation] group box in the [Microscope Configuration] window, select
the <LSM> button.
2. The system setting points to be changed for LSM observation will blink in red.
Change the system configuration (setup of light path selector, barrier filters, etc.) by
following the guidance given by the red blinking light.
The Red blinking indicates where can be changed. The blinking does
not stop even after the indicated configuration setting has been
changed.
3. After completing the system configuration, select the <OK> button.
TIP
NOTE
NOTE
<BI> button
<LSM> button