APPLIED OPERATIONS
/Image Analysis
IV.
OPERATION INSTRUCTIONS
IV .
2 - 2 7 4
Page
2-7-1 Checking the Intensity of a Specific Part
2-7-1-1 Intensity Values on a Line (Line Profile)
The intensity values on a line in an image can be displayed graphically.
1.
Display the [Single] sub-panel at the front.
2.
Display the [Display] panel of the image to be subjected to the intensity checking at
the front.
3. Click the <Annotate> button in the toolbar at the bottom of the [Analyze] panel. A
list of buttons appears as shown below.
4. From the displayed buttons, click the <Line> button, <Poly Line> button or <Free
Line> button.
5. Specify the straight line, polygonal line or free line on the image in the [Display]
panel.
They can be specified as described below.
z
To specify a straight line:
On the image, place the mouse pointer on the point you want to start the
straight line and drag until the point you want to end it.
z
To specify a polygonal line:
On the image, click the points corresponding to the start point, peak points
and end point of the desired polygonal line, then click the right button of the
mouse to set the specification.
<Annotate> button
<Line> button
<Poly Line> button
Содержание FLUOVIEW FV300
