Olympus FLUOVIEW FV300, Руководство пользователя

Страница: 66 / 564

Getting Started FLUOVIEW/
Outline of LSM Observation Procedures
IV.
OPERATION INSTRUCTIONS
IV
. 1 - 2 8
Page
1-2-3 Focusing on the Specimen
1-2-3-1 Combination with BX
1. Select the light path for 100% eyepiece by pushing in the light
path selector knob (1) on the trinocular tube fully to the stop
position.
2. Push the cube button (4) of the hand switch (3) to engage the
optimum cube for specimen dye. In the cube display window
(2), the selected cube is displayed (when using the Motorized
microscope).
Engage the optimum cube for specimen dye by operating the
cube turret(2)(when using the Manual microscope).
3. Focus on the specimen by looking into the eyepiece. Be sure
to adjust the diopter of the eyepiece in advance. (Refer to the
instruction manual of the BX microscope.)
When the Z motor is in use, clear the check mark in the
[Locked] check box in the [Z Stage] sub-panel in the
[Acquire] panel (see section 2-2-1-3-7 of this volume),
then focus on the specimen by operating the fine focus
adjustment knob of the microscope. Be sure not to
operate the fine focus adjustment knob while the
[Locked] check box is checked, for this may damage the
Z motor.
The specimen may float during oil-immersed
observation. In this case, prepare an optional clip for
immersion objective (BH2-SCB-3) and attach as shown
on the left.
NOTE
(1)
Clip for immersion
objective
(2)
(3)
(4)