Oce ColorWave 500, Руководство по эксплуатации

Страница: 37 / 330

Take-up module Illustration
The take-up module enables you to wind up
your prints job on a roll without cutting. This
can be handy when you want to transport
your prints or want to finish your prints at a
later time. When your machine is equipped
with the take-up module, you must first put
the machine into the Roll-to-roll mode. You
can enable the Roll-to-roll mode in Océ Ex-
press WebTools and on the user panel.
NOTE
The take-up module is not suppor-
ted in combination with the [Re-
ceiving rack (basket)], folding de-
vice or Océ Delivery Tray.
See
The take-up module (optional) on
page 40 , Configure the Roll-to-roll mode in
Océ Express Webtools on page 121 and
Configure the Roll-to-roll mode on page 40
Select the finishing device configuration
When to do
On the user panel, you can choose the type of the finishing device. The default value is [No
finisher].
Procedure
1. Tap on the system menu thumbnail in the dynamic bar. The system menu opens.
2. Tap on [Finishing device] in the list in the right part of the display.
3. Log in as a Key operator.
A wizard opens.
4.
Follow the steps in the wizard.
The selection options:
• [No finisher]
• [Océ Delivery Tray]
• [Océ 2400 fanfold]
• [Océ 4311 fullfold series]
• [Océ 4312 fullfold (conveyor belt)]
• [Océ 4313 fullfold (reinforcement unit)]
• [Océ 4314 fullfold (conveyor belt and reinforcement unit)]
Result
After you have followed the steps, restart the system to apply the configuration.
Select the finishing device configuration
Chapter 2 - Get to Know the Printing System 37