NF ZA57630, Инструкция по эксплуатации

Страница: 46 / 246

3.2 Input and Output Connectors
3
-
10
ZA 57630
When using HV DC bias ±40 V
Maximum driving current
: 60 mArms (depends on the measurement range, frequency etc.)
Output impedance : 50 Ω
(When HV DC bias is used, approximately 1 kΩ at approximately
100 Hz or less.)
■ Measurement connectors when power is off
The measurement connectors are connected to the internal circuits even when the power is off.
！
CAUTION
・
Do not apply a large external signal to the measurement connectors. Even when the power is
off, do not apply an external signal. There is a risk of damage to this instrument.
・
Do not connect a charged capacitor. If there is a possibility that the DUT may be charged,
discharge the DUT sufficiently before connecting it. If the DUT is discharged to the
measurement connectors, this instrument may be damaged.
3.2.3 Measurement Connectors (Measurement Mode: IMPD
−
2T)
■ Explanation of connector
PORT3
This is connected to the DUT.
Figure 3-5
Functions of Measurement Connectors (Measurement Mode: IMPD−2T)
■ Measurement signals
The major specifications of the measurement signals are as follows.
Connector : N connector
Signal amplitude : Max. 3 Vrms
DC bias : When using normal DC bias ±5 V
When using HV DC bias ±40 V
50 Ω
～
PORT3
A
DC BIAS
1 kΩ
HV DC BIAS
V