NF ZA57630, Инструкция по эксплуатации

Страница: 147 / 246

3.6 Initial Settings
3
-
111
ZA 57630
3.6 Initial Settings
The settings of this instrument will be the initial settings in the following cases.
・
At the time of shipment from the factory
All the settings are the initial settings. The values in the setting memory are all the
same as the initial values.
・
When the reset command is executed and when the measurement mode is changed
Everything except the setting memory, measurement data, and interface settings is
initialized.
Panel Operation:
[Other]
－
[RESET]
Remote control command:
*RST
command
・
If there is an error with the resume memory where the last settings are stored when the
power is turned on
For details on which settings will be reset to the initial settings, refer to
“Table 3-4 Initial
Settings”.
Whether each parameter is a resume target, measurement data save target, and
sequence target are also displayed. The “Y” and “N” in the table below have the following
meaning.
Y: Setting is initialized
N: Setting is not initialized
Table 3-4 Initial Settings (1/12)
Setting item Parameter range Initial value
Reset
Resum
e
S
save a
s
m
easu
re
ment
dat
a
Se
quen
ce
＜
Mode
＞
(MODE) IMPD−EXT | IMPD−3T |
IMPD−2T | G−PH IMPD−EXT N Y N N
＜
OSC
＞
FREQUECNCY 10 µ to 36 MHz 1 kHz Y Y Y Y
AMPLITUDE UNIT V | A V Y Y Y N
AMPLITUDE 0 to 999 GVrms 1 Vrms Y Y Y Y
AMPLITUDE LIMIT 1 aVrms to 999 GVrms 3 Vrms Y Y N Y
ALC ON|OFF OFF Y Y N Y
TOLELANCE 1 to 100 % 10 % Y Y N Y
RETRY TIMES 1 to 100 10 Y Y N Y
CORR FACTOR 1 to 100 % 100 % Y Y N Y
DC BIAS
DC BIAS −999 GV to +999 GV 0 V Y Y Y Y
HV BIAS OFF|ON OFF Y Y Y N
OUTPUT CONN FRONT | REAR FRONT Y Y N N
POWER AMP GAIN −1.00E−12 to +1.00E+12 +1.00E+00 Y Y N Y