NF ZA57630, Инструкция по эксплуатации

Страница: 25 / 246

2.1 Checking before Use
2
-
3
ZA 57630
■
Options / related products
○ Test fixtures and test leads
Test fixtures and test leads are not included. Please purchase them separately. The major
test fixtures and test leads that can be used in combination with this instrument are as
follows.
Model Product name Supplementary note Frequency range
ZM2363 Test fixture
For lead components DC to 10 MHz
2324 4-terminal alligator clip
test leads
——— DC to 100 kHz
2325AL Kelvin clip test leads
Large sized clips
(Replaceable clips) DC to 100 kHz
2325AM Kelvin clip test leads
Medium sized clips
(Replaceable clips) DC to 100 kHz
ZM2392 Kelvin clip test leads
Simple type DC to 20 kHz
ZM2391 3-terminal alligator clip
test leads
2 signals, 1 shielded DC to 20 kHz
2326A Chip component test leads
Tweezers type DC to 1.2 MHz
ZM2394 Chip test fixture
For SMD & chip parts DC to 2 MHz
ZM2394H Chip test fixture
For SMD & chip parts DC to 36 MHz
The above table lists the test fixtures and test leads that can be used when this instrument is
in the IMPD−3T measurement mode. Any model connected to the DUT by 2 terminals will be
affected by the contact resistance and its variations. Even 4-terminal test fixtures and test
leads will similarly be affected by contact resistance and its variations because the IMPD−3T
measurement mode of this instrument is for a 3-terminal connection. For measurements of
approximately 50 Ω or less, we recommend evaluating the measurement value variations due
to contact resistance using an actual DUT before use.
○ Other options
PA−001−0370
SHUNT RESISTOR
Current-voltage conversion coefficient 1 V/A, rating 1 Arms
For details, refer to the instruction manual.
PA−001−3270
RACK MOUNT KIT (EIA)
This kit is for mounting in an EIA standard rack.
PA−001−3271
RACK MOUNT KIT (JIS)
This kit is for mounting in a JIS standard rack.
！
WARNING
There are high voltage parts inside this instrument. Never remove the cover.
No one except trained service technicians who have knowledge of hazard prevention is
authorized to check the inside of this device.