NF ZA57630, Инструкция по эксплуатации

Страница: 180 / 246

4.5 Setting Sweep Measurement
4
-
22
ZA57630
Table 4-3 Graph Axis Parameters (Measur
ement Mode: IMPD−EXT / IMPD−3T / IMPD−2T) (Continued)
Axis setting Description Unit
C
P
Parallel capacitance F
C
S
Series capacitance F
R
P
Parallel resistance Ω
R
S
Series resistance Ω
Q
C
Quality coefficient (capacitance) None
Q
L
Quality coefficient (inductance) None
D
Dissipation factor (capacitance) None
D
ε
Dissipation factor (relative permittivity) None
D
µ
Dissipation factor (relative permeability) None
V1, V2, V
*1
Voltage amplitude Vrms
I
*1
Current amplitude Arms
FREQ
Frequency Hz
ε
S
Relative permittivity None
ε
S
'
Complex relative permittivity (real part) None
ε
S
''
Complex relative permittivity (imaginary part) None
µ
S
Relative permeability None
µ
S
'
Complex relative permeability (real part) None
µ
S
''
Complex relative permeability (imaginary part) None
*1:
V1
,
V2
,
V
, and I are the voltage and current values measured by this instrument.
Whereas, impedance Z and other parameters are the results after various internal
corrections have been made, so (
Z=V/I
) does not necessary hold true.
Table 4-4 Graph Axis Parameters (Measurement Mode: G
−PH)
Axis setting Description Unit
SWEEP
This is the sweep item.
Select one of the following.
Frequency
measurement signal amplitude
DC bias
ZERO−SPAN
Hz
Vrms / Arms
V / A
s
R
|Gain| None (ratio)
dBR
|Gain| dB
θ
Phase °
a
Gain (real part) None (ratio)
b
Gain (imaginary part) None (ratio)
GD
Group delay s
V1,V2
*1
Voltage amplitude Vrms
FREQ
Frequency Hz
*1:
V1
and
V2
are the voltage values measured by this instrument. Whereas, gain R and
other parameters are the results after various internal corrections have been made, so
(
R=V1 / V2
) does not necessary hold true.