NEC N8100-1668F, Руководство пользователя

Страница: 310 / 572

8-28 Troubleshooting
POST fails to complete:

Is the DIMM board installed?
→
Check the installation location of DIMMs (see Chapter 9).

Is the memory size large?
→
The memory check may take a few seconds if the memory size is large. Wait for a
while.

Did you perform any keyboard or mouse operation immediately after you started the
server?
→
If you perform any keyboard or mouse operation immediately after start-up, POST
may accidentally detect a keyboard controller error and stops proceeding. In such
a case, restart the server once again. Do not perform any keyboard or mouse
operation until the BIOS start-up message appears when you restart the server.

Does the server have contains appropriate memory boards or PCI devices?
→
Operation of the server with unauthorized devices is not guaranteed.
Fail to access to internal or external devices (or such devices fail to operate):

Are cables properly connected?
→
Make sure that the interface cables and power cord are properly connected. Also
make sure that the cables are connected in the correct order.

Is the power-on order correct?
→
When the server has any external devices connected, power on the external
devices first, then the server.

Did you install drivers for connected optional devices?
→
Some optional devices require specific device drivers. Refer to the manual that
comes with the device to install its driver.

Is BIOS configuration correct?
→
Some devices connected to the serial or parallel port may require I/O port address
or operation mode settings. Refer to the manual that comes with the board for
details to make correct settings.
Fail to access to internal RDX device:

Does the lamp on RDX light amber?
→
The RDX device becomes inaccessible when an Eject error occurs. Change
installation location of RDX device according to description in Chapter 9.