Table of Contents
Centauri user manual revision level 01 /2007
55
6.3.
Set up Connection
(a) Via the front panel:
Connections can be established with communications partners in two different ways: either
via the start mask and the connect function, or by means of abbreviated dialling.
1)
Establishing a connection via the start mask
In order to set up a connection to a communications partner via the start mask, proceed as
follows:
•
Select the
CONNECT
option in the Start mask with the arrow key and press
. The
following mask now appears on the display:
Figure 58:
The
CONNECT-DIALOG
mask
•
Select either
DIRECT DIAL
(enter telephone number directly),
LAST
(set up the pre-
vious connection again) or
PHONE BOOK
(select subscriber from the phone book).
If you have selected
LAST
, the device immediately starts establishing the connection.
•
Otherwise you should enter the desired phone number (
DIRECT DIAL
) or select a
subscriber from the phone book.
In the phone book you enter a letter with the letter keys and the list then skips to the first
entry starting with the letter entered.
The device then begins to establish a connection to the desired communications partner.
2)
Establishing a connection by means of abbreviated dialling
In order to establish a connection by means of abbreviated dialling, proceed as follows:
•
Press the
key. The
SPEED
DIAL
mask appears.
Figure 59:
The
SPEED
DIAL
mask
This function is not available if configuration functions are currently being used at the
Merk II (e.g. parameter settings for the audio encoder, scrolling through journal entries
etc.).
•
Press the
key.
•
Enter a number at the keypad with a maximum of two digits which has been assigned
to phone book entry and press the
key.
•
Select
CONNECT
and press the
key.
The device now establishes a connection to the corresponding communications
partner.
