MagneMotion MagneMover LITE, Руководство пользователя, Страница: 192 / 382

Installation
Transport System Installation
6 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Installation Overview – User-Supplied Mounting
This provides an overview of the installation of the MagneMover LITE motors, switches, and
other components on user equipment or a custom stand system.
1. Assemble a complete section of the track, including guideway, motor mounts, and
stand.
2. Level the section of the track where the motors will be mounted (refer to Leveling the
MagneMover LITE on page 5-15 ).
3. Secure the track to the floor or other equipment as required (refer to Securing the
Transport System on page 5-16 ).
4. Install the motors and switches ensuring the guide rails are colinear to each other and
the tops of all motors are coplanar to each other and tighten the V-braces (refer to
Mounting Motors and Switches on page 5-20 , Align and Secure Motors and Switches
on page 5-23 , and Verify Motor and Switch Installation on page 5-26 ).
NOTE: If railless motors are being used ensure the motor bodies are colinear to each
other.
If motors are installed in a Clean-In-Place (CIP) or wash-down environment
it must not exceed IP65.
5. Install the power supplies, Node Controllers, network switches, and cables (refer to
Installing Electronics on page 5-27 ).
6. Install magnet arrays on the vehicles and install the vehicles on the system (refer to
Installing Pucks/Magnet Arrays on page 5-40 ).
NOTE: Vehicles (pucks) should be installed on closed loop systems before installing
the last motor to eliminate the need to remove a guide rail.
7. Make all communications, network, and power connections (refer to Facilities Con-
nections on page 5-60 ).
8. Assemble the next section of the system following Step 1 through Step 7 and connect
it to the previously installed section ensuring both sections are in the same plane and
level to each other.
9. Continue assembling and installing sections until the system is complete.
10. Create the Node Controller Configuration File and install software (refer to Software
on page 5-64 ).
11. Power up the system and check all operating features, safety features, and connections
(refer to
System Check-out on page 5-66 and System Power-up on page 5-67 ).
NOTICE
Ensure the equipment or stand system where the MagneMover LITE motors
will be mounted and the motor mounting surfaces are properly grounded to
safety ground (earth).