MagneMotion MagneMover LITE, Руководство пользователя, Страница: 199 / 382

Installation
Transport System Installation
MagneMover LITE User Manual 13
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
3. Attach the Parallel Path Legs at the appropriate locations (if not already installed) as
shown in
Figure 5-3 .
Figure 5-3: Legs on a Parallel Path Beam Assembly
A. Insert one M8 T-nut and rotate into position in the channel on the side of each
beam where the leg will be attached (T-nuts must be inserted so that the spring
steel tabs are facing toward the beam then rotated clockwise into place).
B. Insert one M8 T-nut and rotate into position in the channel on the top of the leg
where the beam will be attached.
C. Position the leg over the T-nuts using a machinist’s square to ensure it is prop-
erly positioned.
D. Locate an angle bracket at each beam/leg crossing, apply Loctite 243 to two
M8 x 25 mm screws per bracket and install. Tighten enough to secure the
bracket while still allowing it to move.
NOTE: Ensure the angle bracket is configured for 50 mm use by placing the
inserts into the bracket with the hole in the insert to the outside of the
bracket as shown in
Figure 5-4 .
Leg Stand Assembly
M8 T-Nut
(4X)
M8 x 25 mm Screw
(4X)
Beam
Angle Bracket
(2X)