MagneMotion MagneMover LITE, Руководство пользователя, Страница: 218 / 382

Installation
Transport System Installation
32 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
3. Install the mounting flanges onto the power supply using the screws from the bottom
using Loctite 243 and tighten the screws to 0.9 N-m [8 in-lb] using a Phillips bit.
4. Orient the power supply as required and secure it to the T-nuts, apply Loctite 243 to
two M8 screws and install with M8 split lock washers and tighten the screws to
26 N-m [230 in-lb] using a 6 mm Hex bit.
NOTE: The Loctite must cure for 2 hours at 22° C [72° F] before using the transport
system.
5. Install an M5 T-nut and secure a nylon cable tie holder to it using an M5 x 12 mm
screw on the leg as required to secure the cables running to the power supply using
cable ties.
Connecting Motors and Electronics
The MagneMover LITE transport system uses daisy-chained communication with all motors
in the transport system. All motors in a specific Path are chained together with the upstream
end of the chain always connected to a Node Controller and the downstream end connected to
a Node Controller if it terminates in a Node. Power and communications cables can be run in
the cable chase under the motors to protect them from damage and provide easy access for
service. The following procedure provides the information required to make all motor connec-
tions as shown in
Figure 4-1 through Figure 4-8 and Figure 4-43 and Figure 4-44 .
NOTICE
Never connect or disconnect the power lines with power applied to the
MagneMover LITE transport system as damage to internal components may
result.
NOTICE
The Node Controller LITE only supports MagneMotion’s custom Power
over Ethernet (PoE). Never connect the Node Controller LITE to a standard
PoE network as damage to internal components may result.
The NC-12 Node Controller does not support Power over Ethernet (PoE).
Never connect these Node Controllers to a powered Ethernet network as
damage to internal components may result.