MagneMotion MagneMover LITE, Руководство пользователя, Страница: 335 / 382

Maintenance
Repair
MagneMover LITE User Manual 51
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Required Tools and Equipment
• Screwdriver, Phillips #1.
• Loctite 243, Thread locker Anaerobic Adhesive, Blue.
Procedure
The lubricating applicators are attached to the underside of the vehicle between either the con-
centric bearings or the eccentric bearings as shown in
Figure 7-21 . To maintain consistency
between vehicles, and to apply lubricant evenly to both sides of the rail system, MMI recom-
mends that half the vehicles be installed with the applicator between the concentric bearings
and the other half between the eccentric bearings.
NOTE: When installing the vehicles on the rails, alternate the vehicles so that two consecu-
tive vehicles do not have the applicator on the same side.
Figure 7-21: Precision Rail Vehicle Lubricating Applicator Location
NOTE: The felt tip contains a v-groove that must be oriented correctly to the rail. If the
v-groove does not align with the rail excess drag will be created and the vehicle will
not move freely along the rail.
1. Install the applicator at either the eccentric bearing or concentric bearing location by
inserting two M3 x 8 mm screws into the appropriate holes on the top of the vehicle as
shown in
Figure 7-22 .
Figure 7-22: Installing or Removing a Precision Rail Felt Applicator
Concentric
Bearings
Applicator
Applicator
Eccentric
Bearings
Felt Tip
Felt Tip
Mounting holes at
Eccentric Bearings
Mounting holes at
Concentric Bearings