MagneMotion MagneMover LITE, Руководство пользователя, Страница: 233 / 382

Installation
Option Installation
MagneMover LITE User Manual 47
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
3. Loosely secure each support post assembly to the T-nuts using the M8 SHC screws
(finger-tighten then back off one half turn) to provide the parts a small amount of
movement relative to each other to allow adjustment.
NOTE: Ensure the rail mounting edge of the spine plate is oriented towards the
motor.
Attach Rails to Spine Plates
The precision rails are provided as a matched set with adjoining rail ends lettered (engraved)
at the factory as A to A, B to B, C to C, etc. as shown in
Figure 5-30 . Rails typically attach to
spine plates at a joint where two rail ends meet, as shown in Figure 5-31 . However, some rails
may attach to spine plates along the mid-point of a single rail, as shown in Figure 5-32 .
NOTE: Rail segments not used, or rail ends not matched letter to letter, will result in a mis-
match between rail ends and may require installation personnel to hone the rail ends
to achieve acceptable alignment and performance.
Prior to attaching and securing the final rail within the system, all vehicles should be
installed onto the rails by sliding them onto an open section of rail (refer to
Replace
Precision Rail Vehicles on page 7-45 ).
Ensure all rails on parallel paths are parallel.
1. Identify the letters engraved on the end of each rail segment (see Figure 5-30 ) and lay-
out the rails so matching letters (A to A, B to B, C to C etc.) align.
NOTE: If a rail segment is not used or is mislocated, the letters between the joints
will not match. In this case, during alignment and adjustment it may be nec-
essary to hone the ends of the mismatched rails to achieve the proper align-
ment and performance.
Figure 5-30: Precision Rail End Identification
Engraved Letters