MagneMotion MagneMover LITE, Руководство пользователя, Страница: 206 / 382

Installation
Transport System Installation
20 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Mounting Motors and Switches
All motors and switches, with their motor mounts pre-attached, must be attached to the beam
sections. Starting at one end of the system install all switches, then fill in the space between
the switches with the motors.
NOTE: If Precision Locators are being used, install the locator stands before installing the
motors at those locations (refer to
Precision Locator Installation ).
If motors or switches are being mounted to supports other than the MagneMover
LITE stand system, ensure the motors are flat and level once assembled.
When using motors with integral rails, before installing all the motors in a closed
system add the pucks by sliding them onto the end of a motor that has been installed.
Ensure all motors on parallel paths are parallel.
Mounting the motors is the same for motors with rails and for railless motors.
Figure 5-10: Installing Motors and Switches
1. Insert an M8 T-nut in the top channel of the beam at the approximate location for each
motor mount, refer to
Table 5-2 for quantities and locations (T-nuts must be inserted so
that the spring steel tabs are facing toward the beam then rotated clockwise into place).
Locating Boss
M8 x 20 mm Bolt
M8 Lock Washer
M8 T-Nut
Straight Motors (typ) Curve Motors (typ)
Switches (typ)