Lenovo System x3500 M5 Type 5464, Инструкция по установке и обслуживанию

Страница: 86 / 1236

00
0
00
00 00
0
0
Handle
Latch
2.5-inch hot-swap
hard disk drive
2.5-inch fill panel
Figure 59. Hot-swap hard disk drive installation
Notes:
1. After you install the hard disk drive, check the disk drive status LEDs to verify that the hard
disk drive is operating correctly. If the yellow hard disk drive status LED is lit continuously, that
drive is faulty and must be replaced. If the green hard disk drive activity LED is flashing, the
drive is being accessed.
2. If the server is configured for RAID operation through an optional ServeRAID adapter, you
might have to reconfigure your disk arrays after you install hard disk drives. See the ServeRAID
documentation on the
ServeRAID Support CD for additional information about RAID operation
and complete instructions for using ServeRAID manager.
Step 7. Close the bezel (see “Installing the bezel” on page 186).
Step 8. Lock the left-side cover.
Installing a 3.5-inch hot-swap hard disk drive
Use this information to install a 3.5-inch hot-swap SAS/SATA hard disk drive.
Before installing a 3.5-inch hot-swap hard disk drive, read the following information:
• Inspect the drive tray for signs of damage.
• To maintain proper system cooling, do not operate the server for more than 10 minutes without either a
drive or a filler panel installed in each drive bay.
• You do not have to turn off the server to install hot-swap drives in the hot-swap drive bays.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 29.
To install a 3.5-inch hot-swap SAS/SATA hard disk drive, complete the following steps.
70
System x3500 M5 Installation and Service Guide