Lenovo System x3500 M5 Type 5464, Инструкция по установке и обслуживанию

Страница: 115 / 1236

Replacing the air baffle
Use this information to replace the air baffle.
Note: When you install the second microprocessor, you must also install fan 2 and the air baffle that come
with the second microprocessor upgrade kit.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 29.
To replace the air baffle (two microprocessors installed), complete the following steps.
Step 1. Slide the air baffle down into the server until the positioning pins fit into the locating holes; then,
press the release latch and put down the air baffle until it clicks into place.
00
00
00000000000
00000000000
00000000000
00000000000
00000000000
00000000000
00000000000
00000000000
00000000000
00
0
0
00
00
00
00
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
0000000000000
Guide pins
Air baffle
Release latch
Release latch
Figure 90. Air baffle installation
Replacing the left-side cover
Use this information to replace the left-side cover.
Make sure that all cables, adapters, and other components are installed and seated correctly and that you
have not left loose tools or parts inside the server. Also, make sure that all internal cables are correctly routed.
Important: Before you slide the cover forward, make sure that all the tabs on the front, rear, and side of
the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it will be very
difficult to remove the cover later.
To replace the left-side server cover, complete the following steps.
Step 1. Carefully turn the server on its side so that it is lying flat, with the cover-side facing up.
Step 2. Set the bottom edge of the left-side cover on the bottom ledge of the server.
Chapter 2
.
Installing optional devices
99