Lenovo System x3500 M5 Type 5464, Инструкция по установке и обслуживанию

Страница: 223 / 1236

If you have replaced a server component or installed an optional device in the server, you need to reconnect
the power cords and all external cables, and turn on the server and peripheral devices.
Removing a DVD drive
Use this information to remove a DVD drive.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove the DVD drive, complete the following steps.
Step 1. Unlock and remove the left-side cover (see “Removing the left-side cover” on page 182).
Step 2. Open the bezel (see “Removing the bezel” on page 184).
Step 3. Disconnect the DVD drive cables from the back of the DVD drive. (see “Internal cable routing
and connectors” on page 33)
Step 4. Grasp each side of the DVD drive to pull the drive out of the server.
0
0
00
00 00
0
0
Release buttons
DVD drive
Figure 126. Pull the DVD drive out
Step 5. Remove the optical drive retainer clip from the DVD drive and save them for future use.
If you are instructed to return the server component or optional device, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing a DVD drive
Use this information to install a DVD drive.
If you are replacing a drive, make sure that:
• You have all the cables and other equipment that are specified in the documentation that comes with the
new drive.
• You have checked the instructions that come with the new drive to determine whether you must set
any switches or jumpers in the drive.
Chapter 6
.
Removing and replacing components
207