Lenovo System x3500 M5 Type 5464, Инструкция по установке и обслуживанию

Страница: 133 / 1236

The specific procedure for configuring arrays depends on the RAID controller that you are using. For details,
see the documentation for your RAID controller. To access the utility for your RAID controller, complete the
following steps:
Step 1. Turn on the server.
Note: Approximately 10 seconds after the server is connected to power, the power-control button
becomes active.
Step 2. When prompted,
<F1 Setup>
is displayed, press F1. If you have set an administrator password, you
must type the administrator password to access the full Setup utility menu. If you do not type the
administrator password, a limited Setup utility menu is available.
Step 3. Select System Settings
➙
Storage .
Step 4. Press Enter to refresh the list of device drivers.
Step 5. Select the device driver for your RAID controller and press Enter.
Step 6. Follow the instructions in the documentation for your RAID controller.
Updating Systems Director
Use this information to update the Systems Director.
If you plan to use Systems Director to manage the server, you must check for the latest applicable Systems
Director updates and interim fixes.
Note: Changes are made periodically to the website. The actual procedure might vary slightly from what is
described in this document.
Installing a newer version
To locate and install a newer version of Systems Director, complete the following steps:
Step 1. Check for the latest version of Systems Director:
a. Go to http://www.ibm.com/systems/software/director/resources.html.
b. If a newer version of Systems Director than what comes with the server is shown in the
drop-down list, follow the instructions on the web page to download the latest version.
Step 2. Install the Systems Director program.
Installing updates with your management server is connected to the Internet
If your management server is connected to the Internet, to locate and install updates and interim fixes,
complete the following steps:
Step 1. Make sure that you have run the Discovery and Inventory collection tasks.
Step 2. On the Welcome page of the Systems Director web interface, click View updates .
Step 3. Click Check for updates . The available updates are displayed in a table.
Step 4. Select the updates that you want to install, and click Install to start the installation wizard.
Installing updates with your management server is not connected to the Internet
If your management server is not connected to the Internet, to locate and install updates and interim fixes,
complete the following steps:
Step 1. Make sure that you have run the Discovery and Inventory collection tasks.
Step 2. On a system that is connected to the Internet, go to http://www.ibm.com/support/ fixcentral.
Chapter 3
.
Configuration information and instructions
117