Lenovo System x3500 M5 Type 5464, Инструкция по установке и обслуживанию

Страница: 218 / 1236

00
0
00
00 00
0
0
Handle
Latch
2.5-inch hot-swap
hard disk drive
2.5-inch fill panel
Figure 121. Hot-swap hard disk drive installation
Notes:
1. After you install the hard disk drive, check the disk drive status LEDs to verify that the hard
disk drive is operating correctly. If the yellow hard disk drive status LED is lit continuously, that
drive is faulty and must be replaced. If the green hard disk drive activity LED is flashing, the
drive is being accessed.
2. If the server is configured for RAID operation through an optional ServeRAID adapter, you
might have to reconfigure your disk arrays after you install hard disk drives. See the ServeRAID
documentation on the
ServeRAID Support CD for additional information about RAID operation
and complete instructions for using ServeRAID manager.
Step 7. Close the bezel (see “Installing the bezel” on page 186).
Step 8. Lock the left-side cover.
Removing a 3.5-inch hot-swap hard disk drive
Use this information to remove a 3.5-inch hot-swap SAS/SATA hard disk drive.
Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without
either a drive or a filler panel installed in each drive bay.
Read the safety information in “Safety” on page v and “Installation guidelines” on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove a 3.5-inch hot-swap SAS/SATA hard disk drive, complete the following steps.
Step 1. Unlock the left-side cover.
202
System x3500 M5 Installation and Service Guide