Kubota ME8200DTN, Дополнение к руководству по ремонту

Страница: 54 / 192

ME8200DTN, WSM CLUTCH
N2-S9
Separating the Clutch Assembling
1. Remove the clutch from the flywheel.
(When reassembling)
A
Direct the shorter end of the clutch disc boss toward the
flywheel.
A
Apply molybdenum disulphide (Three Bond 1901 or
equivalent) to the splines of clutch disc boss.
A
Install the pressure plate, noting the position of straight pins.
A
Align the center of disc and flywheel by inserting the
clutch center tool. (See page NG-13.)
A
Do not apply grease and oil on the clutch disc facing.
Release Holder and Clutch Lever
1. Draw out the clutch release holder (5) and the release bearing
(2) as a unit.
2. Remove the release fork setting screws (1).
3. Draw out the clutch lever (4) to remove the release fork (3).
(When reassembling)
A
Make sure the direction of the release fork (3) is correct.
A
Inject grease to the release holder (5).
A
Apply grease to the bushing and clutch lever.
A
After tightening the release fork setting screw to the specified
torque, insert a wire through the hole on the setting screw
head and bind with release fork together.
(B) Separating Clutch Assembly
Tightening torque Clutch mounting screw
23.5 to 27.5
2.4 to 2.8
17.4 to 20.3 ft-lbs
0000003429E
Tightening torque
Release fork setting
screw
166.7 to 186.3
17.0 to 19.0
123.0 to 137.4 ft-lbs
(1) Setting Screw (4) Clutch Lever
(2) Release Bearing (5) Release Holder
(3) Release Fork
0000003430E
KiSC issued 04, 2006 A