Kubota ME8200DTN, Дополнение к руководству по ремонту

Страница: 21 / 192

ME8200DTN, WSM GENERAL
NG-8
Changing Transmission Fluid
A
Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) at the bottom
of the transmission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (2).
Refer to "LUBRICANTS, FUEL AND COOLANT". (See
page NG-2.)
4. After running the engine for a few minutes, stop it and check
the oil level again; add oil to prescribed level.
Adjusting Clutch Pedal
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and measure free travel (L)
at top of pedal.
3. If adjustment is needed, loosen the lock nut (1), and turn the
turnbuckle (2) to adjust the clutch rod length.
4. Retighten the lock nut (1).
Changing Front Axle Case Oil
1. To drain the used oil, remove the right and left drain plugs (2)
and filling plug (1) at the front axle gear case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plugs (2).
3. Remove the right and left breather plugs (3).
4. Fill with the new oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See
page NG-2.)
5. After filling reinstall the filling plug (1) and breather plugs (3).
Transmission fluid Capacity
33.0 L
34.9 U.S.qts
29.0 Imp.qts
(1) Drain Plug A : Oil level is acceptable within
(2) Dipstick the range.
(3) Oil Inlet
0000003598E
Clutch pedal free travel
(L) on the pedal
Factory spec.
35 to 45 mm
1.4 to 1.8 in.
(1) Lock Nut (2) Turnbuckle
0000003599E
Front Axle Case Oil Capacity
6.0 L
6.3 U.S.qts
5.3 Imp.qts
(1) Filling Plug (2) Drain Plug
(3) Breather Plug
0000003600E
KiSC issued 04, 2006 A