Kubota ME8200DTN, Дополнение к руководству по ремонту, Страница: 97 / 192

ME8200DTN, WSM TRANSMISSION
N3-S33
Turning Torque of Spiral Bevel Pinion Shaft and Differential
Assembly Combined
1. Reassemble the differential assembly with left and right shims
(3) same as before disassembling.
2. Check that there is backlash. If there is no backlash, move a
left shim to the right.
(Reference)
A
If the thickness of shims is not known, refer to the following.
A
Reassemble the differential assembly with no shim at bearing
support L (1) side and with an adequate number of shim at
bearing support R (2) side. And proceed to the next step.
3. Measure the turning torque by turning the spiral bevel pinion
shaft, and then add a shim to the bearing support R (2) if the
turning torque exceeds the factory specifications, or remove a
shim from there if the turning torque is less than the factory
specifications.
4. And repeat the above procedure until the turning torque
becomes the factory specifications.
(When reassembling)
(Reference)
A
Thickness of adjusting shims :
0.1 mm (0.004 in.) 0.5 mm (0.020 in.)
0.3 mm (0.012 in.)
Turning torque Factory spec.
4.22 to 5.88
0.43 to 0.60
3.11 to 4.34 ft-lbs
Tightening torque Staking nut
117.7 to 127.5
12 to 13
86.8 to 94.0 ft-lbs
(1) Bearing Support L (3) Shim
(2) Bearing Support R
0000003496E
KiSC issued 04, 2006 A