Kubota ME8200DTN, Дополнение к руководству по ремонту

Страница: 166 / 192

ME8200DTN, WSM HYDRAULIC SYSTEM
N8-S10
Checking Floating Position
1. Attach the weight of 490 N (50 kgf, 110 lbs) to the end of lower
link.
2. Set the position control lever (1) and draft control lever (2) to
the lowest position, and set the engine speed at the maximum.
3. Gradually move the position control lever (1) until the lower
link begins to rise.
4. Check the distance L.
5. If the specified play is not obtained, readjust the feedback rod.
(Refer to "Adjusting Uppermost Position", page N8-S9.)
Adjusting Top Link Bracket
1. Measure the clearance A between the stopper (4) and top link
bracket (1).
If the clearance is not within the factory specifications, adjust
with the shims (5) between the stopper (4) and top link bracket
(1).
(Reference)
A
Thickness of shim (5) : 0.5 mm (0.020 in.)
Adjusting Draft Control Rod
1. Attach a weight of approx. 490 N (50 kgf, 110 lbs) to the end
of the lower link.
2. Set the position control lever (1) to the lowest position
3. Start the engine and set the speed at 1000
(rpm).
4. Set the draft control lever (2) to the uppermost position.
5. Lengthen the draft control rod (3) by turning the turnbuckle
until the relief valve begins to be operated.
6. From the draft control rod position obtained above 5, turn the
turnbuckle by 1/2 turn to shorten the draft control rod, then
tighten the lock nut.
Distance L Factory spec.
25 to 35 mm
0.98 to 1.38 in.
(1) Position Control Lever (2) Draft Control Lever
0000003626E
Clearance A Factory spec.
7.0 to 8.0 mm
0.276 to 0.315 in.
(1) Top Link Bracket (4) Stopper
(2) Torsion Bar (5) Shim
(3) Draft Control Rod
0000003565E
Draft control rod length Factory spec.
Approx. 215 mm
8.46 in.
(1) Position Control Lever (3) Draft Control Rod
(2) Draft Control Lever
0000003294E
KiSC issued 04, 2006 A