Kubota ME8200DTN, Дополнение к руководству по ремонту

Страница: 96 / 192

ME8200DTN, WSM TRANSMISSION
N3-S32
Spiral Bevel Pinion Shaft
1. Remove the stake of staking nut (1).
2. Set the staking nut locking wrench (2).
3. Set the spiral bevel pinion shaft turning wrench.
4. Turn the spiral bevel pinion shaft turning wrench to the
counterclockwise, then remove it.
5. Tap out the shaft to the rear.
(When reassembling)
A
Replace the staking nut with a new one, and be sure to adjust
the turning torque of spiral bevel pinion shaft only. (See page
N3-S32.)
A
Stake the staking nut after installing the differential assembly.
(2) Servicing
Turning Torque of Spiral Bevel Pinion Shaft Only
1. Reassemble the spiral bevel pinion shaft and tighten the
staking nut (2) with locking wrench and turning wrench.
2. After striking the bevel pinion shaft to the front and rear,
retighten the staking nut (2) to specified torque.
3. Measure the turning torque of spiral bevel pinion shaft.
4. If the measurement is not within the factory specifications,
adjust the tightening torque of staking nut (2).
(When reassembling)
(Reference)
A
Thickness of adjusting collar (1) :
1.00 mm (0.039 in.) 2.00 mm (0.079 in.)
1.50 mm (0.059 in.) 2.10 mm (0.083 in.)
1.70 mm (0.067 in.) 2.20 mm (0.087 in.)
1.75 mm (0.069 in.) 2.25 mm (0.089 in.)
1.80 mm (0.071 in.) 2.30 mm (0.091 in.)
1.90 mm (0.075 in.)
A
Stake the staking nut after performing adjustments
described in the following pages.
Tightening torque
Spiral bevel pinion shaft
staking nut
117.7 to 127.5
12 to 13
86.8 to 94.0 ft-lbs
(1) Staking Nut (2) Locking Wrench
0000003494E
Turning torque Factory spec.
2.94 to 3.42
0.30 to 0.35
2.17 to 2.53 ft-lbs
Tightening torque Staking nut (2)
117.7 to 127.5
12 to 13
86.8 to 94.0 ft-lbs
(1) Collar 1 (2) Staking Nut
0000003495E
KiSC issued 04, 2006 A