Kubota ME8200DTN, Дополнение к руководству по ремонту

Страница: 20 / 192

ME8200DTN, WSM GENERAL
NG-7
[2] CHECK POINTS OF INITIAL 50 HOURS
Replacing Hydraulic Oil Filter
A
Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plug at the bottom of the transmission case
and drain the oil completely into the oil pan.
2. After draining reinstall the drain plug.
3. Remove the two oil filters (1).
4. Clean off metal fillings with clean rags at the magnetic filters
(2).
5. Put a film of clean transmission fluid on rubber seal of new
filters.
6. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand and additional 1/2 turn only.
7. After the new filter has been replaced, fill with the oil up to the
upper notch on the dipstick (3).
8. After running the engine for a few minutes, stop it and check
the oil level again, add oil to the prescribed level.
9. Make sure that the transmission fluid doesn't leak through the
seal.
A
To prevent serious damage to the hydraulic system, use
only a KUBOTA genuine filter.
(1) Hydraulic Oil Filter A : Oil level is acceptable within
(2) Magnetic Filter (Clean off Metal this range.
Fillings)
(3) Dipstick
(4) Oil Filling Plug
0000002265E
KiSC issued 04, 2006 A