Kubota ME8200DTN, Дополнение к руководству по ремонту

Страница: 149 / 192

ME8200DTN, WSM STEERING
N7-S4
(2) Removing Steering Cylinder
Tie-rod
1. Remove the cylinder cover (1).
2. Disconnect the power steering hoses (2), (3) from cylinder.
3. Remove the set screw.
4. Place a disassembly stand under the engine and support it
with a jack.
5. Pull out the cotter pin and remove the tie-rod end nuts.
6. Disconnect the tie-rod end with a tie-rod end lifter (Code No.
07909-39051).
(When reassembling)
A
After tightening the tie-rod end nut to the specified torque,
install a cotter pin as shown in the figure left.
Steering Cylinder
1. Remove the tie-rod joint (1) (right and left).
2. Remove the elbows (2) from steering cylinder.
3. Remove the internal snap ring (3).
4. Draw out the steering cylinder to the left.
(When reassembling)
A
Apply liquid lock (Three Bond 1372 or equivalent) to the tie-rod
joint.
Tightening torque
Tie-rod end nut
77.5 to 90.2
7.9 to 9.2
57.2 to 66.5 ft-lbs
Power steering hose
retaining nut
24.5 to 29.4
2.5 to 3.0
18.1 to 21.7 ft-lbs
Cylinder cover
48.1 to 55.8
4.9 to 5.7
35.5 to 41.2 ft-lbs
(1) Cylinder Cover (3) Power Steering Hose 2
(2) Power Steering Hose 1
0000003543E
Tightening torque
Tie-rod joint and
steering cylinder
mounting screw 166.6 to 196.0
17.0 to 20.0
122.9 to 144.6 ft-lbs
(1) Tie-rod Joint (3) Internal Snap Ring
(2) Elbow
0000003544E
KiSC issued 04, 2006 A