Kronoterm WPG 30, Руководство пользователя

Страница: 15 / 64

6.2018
15
Use the button to choose the parameter
Langugage EN (Jezik SI, Lingua IT, Sprache DE,
Jezik CRO).
Press
to go it to SET mode and use the
button to select the desired language.
To confirm the settings press key
(ENTER).
4
Quick settings
NOTE
The parameters of the TERMOTRONIC controller were set according to project
documentation of the heating/cooling system, recommendations of the manufacturer of
the device and your requests by the authorised contractor for commissions at
commission. At handover, the contractor for commissions is obliged to thoroughly
present you with the possible ways of the device’s operation and explain the setting
modes of the parameters important for the user.
The basic function of the device is space heating and heating the DHW. The controller of the device
calculates the optimal needed temperature of the heating water to achieve the desired air
temperature of the room in dependence on the outside temperature.
Setting the temperature of heating/cooling
The temperature in the heated/cooled room is controlled in two stages, by setting the temperature:
1. of the room with the spatial corrector or thermostat and
2. the heating/cooling water in the accumulator and heating/cooling circuits on the controller
TERMOTRONIC .
NOTE
In case despite the change in the setting of the temperature with the spatial corrector or
thermostat after a longer period of operation of the heating/cooling circuit (in floor
heating this could last up to 4 days) the desired room temperature was not achieved,
check the heating water temperature settings. For settings see chapter 4.2.
4.1.1 Setting room temperature with the spatial corrector KT-2
The spatial corrector KT-2 enables an advanced and very easy settings of room temperature and
basic functions of the device.
By pressing the key or the
display displays the currently set
room temperature. The temperature
is marked by an orange border.
By pressing the key
or again
you adjust the desired room
temperature.
You confirm the
change by pressing the OK button,
although, the change auto-saves in
8 seconds.
C/W ALL I
D8-PV Cooling
Silent mode
>Language
EN <