Art. No. SC 1000 KNX
Sensor evaluation
Operating elements on the touch surface can - depending on the underlying function - be
evaluated as a rocker switch (double-surface principle) or as a button (single surface principle).
A rocker or button evaluation can be configured for the following KNX functions...
-
Switching
-
Dimming (Start/Stop)
-
Venetian blind/shutter (Step/Move/Step)
The following functions are always executed as a rocker function...
-
Dimming (Brightness value)
-
Venetian blind/shutter (Position)
-
Operating mode switchover, internal
-
Setpoint shift, internal
-
Fan controller, internal
Since the functions listed below only implement simple commands, only a push-button function
is provided for this purpose...
-
Scene extension
-
1-byte value transmitter
-
2-byte value transmitter
The function as rocker or button does not depend on the configured operation concept (see
page 76-77) d can therefore be used individually for a selection operation as well as for a direct
operation. Only the operating areas differ for buttons or rockers depending on the operation
concept. With the direct operation, the display area is also the operating area of the buttons or
rockers as well. With the selection operation, the buttons or rockers are arranged in a separate
operating area next to the display area.
With the function as a button, the operating element can be touched anywhere. The preset
push-button function will then always be executed (figure 25). With the rocker function, the
operating element is divided into two sensor areas. These sensor areas are one above the
other and must be operated separate from each other (figure 26). It is not permissible to operate
both sensor areas of a rocker simultaneously.
Figure 25: Example of sensor evaluation for direct operation (channel function: Switching)
left: rocker / right: button
Page 78 of 347
Software "Smart Control 501511"
Functional description
