Art. No. SC 1000 KNX
Scene 6 Recall via
extension object with
scene number
number is required for each of them.
This parameter serves to specify the
extension number of the sixth scene.
Scene 7 Recall via
extension object with
scene number
1...
7
... 64
If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the seventh scene.
Scene 8 Recall via
extension object with
scene number
1...
8
... 64
If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the eighth scene.
h
Scene -> Scene output 1
Data type
Switching
Value (0 … 255)
Value / position of Venetian
blind (0 … 100%)
Selection of the data format of the scene
output.
Scene 1
Switching command
ON
OFF
The switching command of the first
scene can be predefined here.
This parameter is only visible if "Data
type = Switching".
Scene 1
Value (0 … 255)
0
...255
The value of the first scene can be
predefined here.
This parameter is only visible if "Data
type = Value (0...255)".
Scene 1
Value / position of
Venetian blind
(0 … 100 %)
0
...100
The value of the first scene can be
predefined here.
This parameter is only visible if "Data
type = Value / Venetian blind
(0...100%)".
Scene 1
Allow save?
Yes
No
If the user is to be given the possibility of
changing the value of the scene and of
storing it while the system is running,
this parameter must be set to "Yes".
Scene 1
Allow transmission?
Yes
No
If the state of an actuator group is to
remain unchanged during the recall of a
scene, this parameter can be set to
"No". In this case, the device does not
transmit a telegram via the scene output
Page 343 of 347
Software "Smart Control 501511"
Parameters
