Jeep GLADIATOR 2023, Руководство пользователя

Страница: 17 / 420

GETTING TO KNOW YOUR VEHICLE 15
To Lock/Unlock The Doors And Tailgate
Push and release the unlock button on the key fob once to
unlock the driver’s door, or twice to unlock all the doors.
To lock all the doors, push the lock button once.
When the doors are unlocked, the turn signals will flash
and the illuminated entry system will be activated. When
the doors are locked, the turn signals will flash and the
horn will chirp.
NOTE:

All doors can be programmed to unlock on the first
push of the unlock button through Uconnect Settings
Ú
page 199.

The mechanical flip key can be used to lock or unlock
the doors, tailgate, glove compartment, storage
compartments (if equipped), and rear seatbacks.
Key Left Vehicle Feature
If a valid key fob is no longer detected inside the vehicle
while the vehicle’s ignition system is in the ON/RUN or
START position, the message “Key Fob Has Left The
Vehicle” will be shown in the instrument cluster display
along with an interior chime. An exterior audible and visual
alert will also be activated to warn the driver.
The vehicle’s horn will rapidly chirp three times along with
a single flash of the vehicle’s exterior lights.
NOTE:

The doors have to be open and then closed in order for
the vehicle to check for the presence of a key fob; the
Key Left Vehicle feature will not activate until all of the
doors are closed.

These alerts will not be activated in situations where
the vehicle’s engine is left running with the key fob
inside.
Replacing The Battery In The Key Fob
The recommended replacement battery is CR2450.
NOTE:
 Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin battery
dimensions.

Perchlorate material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate for
further information.

Do not touch the battery terminals that are on the back
housing or the printed circuit board.

When a key fob battery is low, a warning will be
indicated on the vehicle’s instrument cluster, and the
fob LED will no longer illuminate with a button push.
1. Remove the back cover of the key fob by inserting a
flat-blade screwdriver into the slot on the bottom of
the fob. Apply light pressure until the cover unsnaps
being careful not to damage the seal. Proceed
counterclockwise (in the order shown in the
following image) to loosen the remaining snaps until
the battery cover can be removed.
1-3 – Back Cover Pry Points
2
23_JT_OM_EN_USC_t.book Page 15