hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 58 / 302

www.acornfiresecurity.com
SECTION 3 (CONT)
WIRING CONNECTIVITY
Connect the two antennae on the RF PCB located under
the main processor PCB. The RF PCB is reached by
releasing the Translator Module Processor PCB. The
antennae should be connected as shown and the grey
protective antenna sheath should then be connected
into the Translator Module moulding to ensure the IP rating of the
module is not affected.
The figure below shows the location of the push-buttons used during the programming process. It also
indicates the location of the Translator Module LEDs - the use of these LEDs is explained throughout
this manual. Detection loop connectivity is also shown:
DIODE LIGHT (LED)
DL3
DIODE LIGHT (LED)
DL2
DIODE LIGHT (LED)
DL1
DIODE LIGHT (LED)
DL4
DIODE LIGHT (LED)
DL5
DIODE LIGHT (LED)
DL6
PUSHBUTTON P1
Exit out of a sub-menu. Allows the user to exit from a menu if do not want to
accept changes made.
PUSHBUTTON P2
To enter into a menu. Allows the user to enter sub-menus or to
confirm changes made to system parameters or devices.
PUSHBUTTON P3
To navigate through menus. To change system parameters
(increase)
PUSHBUTTON P4
To navigate through menus. To change system parameters
(decrease)
WCTM Issue 3 Page 30 of 155
L
O
O
P OU
T
PU
T
+
L
O
O
P OU
T
PU
T
-
L
O
O
P I
N
PU
T
+
L
O
O
P I
N
PU
T
-