hyfire HFW-W2W-01, Руководство по настройке системы

Страница: 299 / 302

www.acornfiresecurity.com
SECTION 8 (cont)
Insert the Primary power cell in the new device. Wait until the RF device LED indicator has
blinked RED 4 times (to indicate the device has entered programming mode). Switch the RF
device jumper from ON to the 1 position. The RF device LED will flash GREEN (showing that
initial programming is completed). On completion the following window will be displayed:
Press . The device may then flash RED for a short period of time. The device will then
flash GREEN two more times before extinguishing.
The device has now been changed and should be put back in to its installed position. This is all
that is required of the engineer to change a device.
(Some engineers may choose to carry out a "Program TRANSLATOR" process followed by a
"LOAD" command at the Translator Module itself. This is only necessary if a NEW device is
added to the existing system).
The above process can be carried out if there is a requirement to change a device on an
Expander Module. The process is very similar. Download the whole program (following the
procedure detailed in pages 143-148). When all the information is available to the engineer, the
process to replace a device on an Expander Module is the same as for replacing a device on a
Translator Module - the only difference is if the engineer is connected to the Translator Module
or to the Expander Module. If the computer is connected to the Expander Module, the procedure
detailed above is to be followed. If the computer is connected to the Translator Module, then a
remote replacement process should be followed.
Ensure the device is removed from its installed position and that the power cells are removed.
Unpack the new device inserting the Secondary power cell in to the device and moving the
device "Programming " switch to the "ON" position.
At the Wirelex software, ensure the "Configuration" tab is displayed and that the required
Expander Module is highlighted in the "Radiosystem topology" area. Highlight the device to
be changed in the "Child device" area. Right click on the device highlighting "Remote
programming (through TXLTR)" and "Re-initiate device" (see image overleaf).
WCTM Issue 3 Page 153 of 155